Author:
Publisher:
Published: 2002
Total Pages: 16
ISBN-13:
DOWNLOAD EBOOKOpen loop, experimental force and power measurements of a three-axis, radial, heteropolar magnetic bearing at room temperature for rotor speeds up to 20,000 RPM are presented in this paper. The bearing, NASA Glenn Research Center's and Texas A & M's third generation high temperature magnetic bearing, was designed to operate in a 1000 deg. F (540 deg. C) environment and was primarily optimized for maximum load capacity. The experimentally measured force produced by one C-core of this bearing was 630 lb. (2.8 kN) at 16 A, while a load of 650 lbs (2.89 kN) was predicted at 16 A using 1D circuit analysis. The maximum predicted radial load for one of the three axes is 1,440 lbs (6.41 kN) at room temperature. The maximum measured load of an axis was 1050 lbs. (4.73 kN). Results of test under rotating conditions showed that rotor speed has a negligible effect on the bearing's load capacity. A single C-core required approximately 70 W of power to generate 300 lb (1.34 kN) of magnetic force. The room temperature data presented was measured after three thermal cycles up to 1000 deg. F (540 deg. C), totaling six hours at elevated temperatures.
Book Synopsis Room Temperature Characterization of a Magnetic Bearing for Turbomachinery by :
Download or read book Room Temperature Characterization of a Magnetic Bearing for Turbomachinery written by and published by . This book was released on 2002 with total page 16 pages. Available in PDF, EPUB and Kindle. Book excerpt: Open loop, experimental force and power measurements of a three-axis, radial, heteropolar magnetic bearing at room temperature for rotor speeds up to 20,000 RPM are presented in this paper. The bearing, NASA Glenn Research Center's and Texas A & M's third generation high temperature magnetic bearing, was designed to operate in a 1000 deg. F (540 deg. C) environment and was primarily optimized for maximum load capacity. The experimentally measured force produced by one C-core of this bearing was 630 lb. (2.8 kN) at 16 A, while a load of 650 lbs (2.89 kN) was predicted at 16 A using 1D circuit analysis. The maximum predicted radial load for one of the three axes is 1,440 lbs (6.41 kN) at room temperature. The maximum measured load of an axis was 1050 lbs. (4.73 kN). Results of test under rotating conditions showed that rotor speed has a negligible effect on the bearing's load capacity. A single C-core required approximately 70 W of power to generate 300 lb (1.34 kN) of magnetic force. The room temperature data presented was measured after three thermal cycles up to 1000 deg. F (540 deg. C), totaling six hours at elevated temperatures.
